User Manual

30
Spilled rinse aid can cause excessive
frothing during the wash cycle.
4. Close the lid of the dispenser for
rinse aid.
a The lid clicks into position.
Setting the amount of rinse
aid
If there are streaks or water marks on
tableware, change the amount of rinse
aid.
1.
Press ⁠.
2. Hold programme button A and press
repeatedly until the display
shows H:xx.
3. Release programme button A and
⁠.
a Programme button A flashes and the
display shows H:04.
4. Press programme button A re-
peatedly until the display shows the
value set at the factory r:05.
5. Press programme button C re-
peatedly until the right amount of
rinse aid has been set.
– A low setting adds less rinse aid
during the wash cycle and reduces
streaking on tableware.
– A higher setting adds more rinse
aid during the wash cycle, reduces
water marks and improves the
drying result.
6.
Press to save the setting.
Switching rinse aid system
off
If you find the rinse aid refill indicator ir-
ritating, e.g. when using combined de-
tergents with a rinse aid component,
you can switch the rinse aid system off.
Tip:The function of rinse aid is limited
with combined detergents. You will
generally get better results using rinse
aid.
1.
Press ⁠.
2. Hold programme button A and press
repeatedly until the display
shows H:xx.
3. Release programme button A and
⁠.
a Programme button A flashes and the
display shows H:04.
4. Press programme button A re-
peatedly until the display shows the
value set at the factory r:05.
5. Press programme button C re-
peatedly until the display shows r:00.
6.
Press to save the setting.
a The rinse aid system is switched off
and the rinse aid refill indicator is de-
activated.