User Manual

26
Before using for the first time
Before using for the first time
Before using for the first time
Configure the settings for initial start-
up.
Performing the initial con-
figuration
On initial start-up or after a reset to the
factory settings, you will need to make
settings.
Requirement:"The appliance has been
installed and connected." →Page14
1. "Add special salt." →Page27
2. "Add rinse aid." →Page29
3. "Switch on the appliance."
→Page35
4. "Setting the water softening system."
→Page27
5. "Set the amount of rinse aid to be
dispensed." →Page30
6. "Add detergent" →Page31.
7. Start the Programme with the
highest cleaning temperature
without tableware.
We recommend you clean the appli-
ance without tableware before using
it for the first time to remove any
marks from water or other residues.
Tip:You can change these settings and
other "Basic settings" →Page38 at any
time.
Water softening system
Water softening system
Water softening system
Hard water leaves limescale on the tub
and tableware and parts of the appli-
ance may become blocked.
To ensure good dishwashing results,
you can treat the water with special salt
and the water softening system. To
avoid damage to the appliance, water
with a hardness above 9 °E must be
softened.
Overview of water hardness settings
You can find an overview of the water hardness values that can be selected here.
You can find out how hard your water is from your local water company or by using
a water hardness tester.
WATER HARDNESS
°E
HARDNESS RANGE MMOL/L SETTING VALUE
0 - 8 Soft 0 - 1.1 H:00
9 - 10 Soft 1.2 - 1.4 H:01
11 - 12 Medium 1.5 - 1.8 H:02
13 - 15 Medium 1.9 - 2.1 H:03
16 - 20 Medium 2.2 - 2.9 H:04
21 - 26 Hard 3.0 - 3.7 H:05
27 - 38 Hard 3.8 - 5.4 H:06