User Manual
ENGLISH 4
Only use utensils that are
suitable for microwave cooking.
Do not use metallic containers -
risk of injury.
Only use a temperature
probe recommended for this
oven - risk of re.
If smoke is emitted switch off
or unplug the appliance and
keep the door closed in order to
stie any ames.
If the appliance is installed
850 mm or more above the
oor, take care not to displace
the turntable when removing
containers – risk of injury.
Do not use your microwave
oven for deepfrying, because
the oil temperature can not be
controlled.
Metallic containers for food
and beverages are not suitable
during microwave cooking.
Do not remove the microwave
inlet protection plates on the
side of the cavity walls (certain
models only). They prevent
grease and food particles from
entering the microwave inlet
channels.
PERMITTED USE
CAUTION: The appliance is
not intended to be operated by
means of an external switching
device, such as a timer, or
separate remote controlled
system.
This appliance is intended
to be used in household and
similar applications such as: staff
kitchen areas in shops, ofces
and other working environments;
farm houses; by clients in hotels,
motels, bed & breakfast and
other residential environments.
This appliance is not for
professional use. Do not use the
appliance outdoors.
INSTALLATION
The appliance must be
handled and installed by two or
more persons - risk of injury. Use
protective gloves to unpack and
install - risk of cuts.
Installation, including
water supply (if any), electrical
connections and repairs must
be carried out by a qualied
technician. Do not repair
or replace any part of the
appliance unless specically
stated in the user manual.
Keep children away from the
installation site. After unpacking
the appliance, make sure that
it has not been damaged
during transport. In the event of
problems, contact the dealer or
your nearest Aftersales Service.
Once installed, packaging waste
(plastic, styrofoam parts etc.)
must be stored out of reach of
children - risk of suffocation. The
appliance must be disconnected
from the power supply before