User Manual

Ignition of the burner
Always ignite the burner before
you place the pots or pans.
To ignite the burner:
1. Push the control knob and turn it
anticlockwise to the maximum position
marked with .
2. Keep the control knob pushed for about
5 sec. As a result thermocouple heats
up, and the safety device switches off. If
you do not push the knob, the gas
supply is interrupted.
3. When you light the flame, you can
adjust it.
If the burner does not ignite,
after a few attempts, check if the
crown and its cap are in correct
positions.
1
2
3
4
5
1
Burner cap
2
Burner crown
3
Ignition candle
4
Injector
5
Thermocouple
Warning! Do not keep the
control knob pressed for more
than 15 seconds. If the burner
does not light after 15 seconds,
release the control knob, turn it
into off position and wait for at
least 1 minute before trying to
light the burner again.
If there is no electricity, you can
ignite the burner without an
electrical device. In this case,
approach the burner with flame,
push the relevant knob and turn
it anticlockwise to the maximum
gas release position.
Warning! Be careful when you
use open fire in the kitchen
environment. The manufacturer
declines any responsibility in
case of misusing the flame.
If the burner accidentally goes
out, turn the control knob to the
off position and wait for at least
1 minute before trying to light it
again.
When you switch on the mains
after installation or a power cut,
the spark generator activates
automatically.
The hob is supplied with the
progressive valves. They make
the flame regulation more
precise.
Turning the burner off
To put the flame out, turn the relevant
control knob to the symbol .
ENGLISH
12