User Manual

15ENGLISH
• After defrosting, connect the appliance to
the power supply.
Caution! To avoid damaging the frozen-
food compartment wall, do not use any
sharp objects to remove the frost or
separate the frozen food.
Troubleshooting
Warning! Refer to Safety chapters.
What to do if...
Problem Possible Cause Solution
The appliance does not operate.
The appliance is switched o. Switch on the appliance.
The mains plug is not connected to the
mains socket correctly.
Connect the mains plug to the
mains socket correctly.
There is no voltage in the mains socket.
Connect a dierent electrical
appliance to the mains socket.
Contact a qualied electrician.
The appliance is noisy. The appliance is not placed stably.
Level the feet of the appliance
to stabilize it. Refer to "Levelling
feet", or the separate Assembly
Instructions
The lamp does not work. The lamp is defective. Refer to “Replacing the lamp”.
The compressor operates
continually.
Temperature is set incorrectly. Refer to “Operation” chapter.
Many food products were inserted at the
same time.
Wait some hours and then check
the temperature again.
The room temperature is too high.
Refer to climate class chart on the
rating plate.
Food products placed in the appliance
were too warm.
Allow food products to cool to
room temperature before storing.
The door is not closed correctly. Refer to “Closing the door”.
The temperature in the appliance
is too low/too high.
The temperature is not set correctly. Set a higher/lower temperature.
The door is not closed correctly. Refer to “Closing the door”.
The food products temperature is too
high.
Let the food products temperature
decrease to room temperature
before storage.
Many food products are inserted at the
same time.
Insert less food products at the
same time.
The thickness of the frost is greater than
4-5mm.
Defrost the appliance.
The door has been opened often. Open the door only if necessary.
There is no cold air circulation in the
appliance.
Make sure that there is cold air
circulation in the appliance.