User Manual

9ENGLISH
3. After cleaning the grease lter, remount in
reverse order ensuring the entire extraction
surface is covered.
Charcoalltermaintenance(ifthehoodis
installedinrecirculationinstallation)
1. Pull out the plug or disconnect the power
supply.
2. Remove the grease lter
3. If the carbon lters are already tted (two
lters that cover the protective grilles for the
motor impeller) and have to be replaced,
turn the central handle anti-clockwise to
unlock them.
4. Open the two lter shells
5. Pull out the two circular mats
6. Proceed in reverse order to t the new
lters.
7.  Ret the grease lters.
Unlike traditional charcoal lters, this
charcoal lter can be washed and
reactivated.
Care and cleaning long life Charcoal lter
• The anti-odour lter shall be washed and
regenerated every 3-4 months (or more
frequently if the hood is subject to intensive
use), up to a Max. of 8 regeneration cycles
(in case of particularly intensive use it is
recommended that you do not exceed 5
cycles).
Regeneration procedure:
• Wash in the dishwasher at a MAX
temperature of 70° or hand wash in hot
water without using abrasive sponges (do
not use detergents!)
• Dry in the oven at a MAX temperature of
70° for 2 hours or dry at room temperature,
standing the lter in a vertical position to
facilitate drainage.
Lampmaintenance
1. Disconnect the hood from the power
supply.
2. Open the extractor grille or remove the
self-supporting grease lter.
3. Replace the damaged lamp. Use E14 3W
max LED lamps only.
4. Ret the extractor grille or grease lter.
IMPORTANT: make sure you don’t touch the
lamp with your bare hands.
Lamp Power
(W)
Socket Voltage
(V)
LCL ILCOSDCode
3 E14 230 55
DRGSB/C/UB-3/27/
1B-230-E14-55