Installation guide

Roof Venting Installation Only
1. Repeat Step 1 from “Wall Venting Installation Only.” 6. Reattach blower motor to back of microwave oven with
2. Repeat Step 2 from “Wall Venting Installation Only.” 2 screws removed in Step 3 of “Wail Venting Installation Only.”
, . . ” Securely tighten screws.
3. Repeat Step 3 from “Wall Venting Installation Only. . .
« . . ” NOTE: If blower motor is not correctly oriented, the 2 screws
4. Repeat Step 4 from “Wall Venting Installation Only. removed in Step 3 cannot be reattached to the microwave oven.
5. Rotate blower motor so that exhaust ports face the top of 7. Reattach damper plate. Make sure damper plate tabs are
microwave oven, and flat sides of blower motor face back of inserted into the slots in the top of the microwave oven
microwave oven. Lower blower motor back into microwave ,
oven.
Cc
A. Damper plate
A. Exhaust port B. Screws
» EXMNAUSE POF C. Damper plate tabs
IMPORTANT: If blower motor is not positioned with flat sides D. Slots
facing Poon of the microwave oven (as shown), performance 8. Secure damper plate with 2 screws removed in Step 1 of “Wall
Venting Installation Only.”