Installation guide

INSTALLATION INSTRUCTIONS
a ey lynehprll Henan A Alem erwaasem cee fe
install Spacer Sirips install the Microwave Oven
The provided self-adhesive spacer strips must be installed on the ( 24" (6 4) Ocm 1) installation Only)
cutout floor, as shown below. They are to be installed under the i :
feet of the microwave oven. This raises the microwave oven 1/8" vedi tad neta tater the mounting brackets must be
(3 mm) to ensure enough clearance for the door to open fully, ; g pening.
without obstruction from an installed lower appliance. To Attach Mounting Brackets:
1. Hold the bracket firmly against the side rim of the opening, as
shown.
The tiered edge of the bracket should be flat against the inside
wall of the opening. The small tier should rest against the floor
of the cutout opening.
a aa ym
oT
B o onsssnssasion
oD
A. Spacer strips in place C
B. Centerline
To Install Spacer Strips:
1. Mark centerline on floor of cutout opening. Or
2. Measure and mark 10%" (26.4 cm) out on either side of >
centerline. 2
3. Remove adhesive backing from each strip.
4. Place one spacer strip flush with the front edge of the cutout
opening. Make sure it is centered at 10%" (26.4 cm) out from
centerline, as shown. ne
M—
ee
5. Place second spacer strip directly behind the first spacer
strip.
6. Repeat on other side. A. Mounting bracket C. Small tier
B. Tiered edge (shaded) D. Cutout floor
2. Using a drill with 5/64" (2 mm) bit, drill pilot holes through the
2 holes in the tiered edge.
3. Secure the bracket to the opening side rim with two 1/2" T-10
screws.
0
eee
eo
NS
NA
A
S
/°
/
f
/
/
é
oe
é
8
A. Tiered edge
B. T-10 screws
4. Repeat on other side.