AU HÖGKLASSIG
ENGLISH Please refer to the chapter IKEA GUARANTEE for contact details of the after sales customer service centre.
ENGLISH 4
ENGLISH Contents Safety information Conditions of Use Safety instructions Installation Electrical connection Product description Daily use Flexible induction cooking area 4 6 6 8 9 10 12 14 Hints and tips Care and cleaning Troubleshooting Technical data Energy efficiency Environmental concerns IKEA guarantee 19 19 20 23 23 24 24 Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions.
ENGLISH • • • 5 Keep children and pets away from the appliance when it operates or when it cools down. Accessible parts may become hot during use. If the appliance has a child safety device, it should be activated. Children shall not carry out cleaning and user maintenance of the appliance without supervision. General Safety • • • • • • • • • • • WARNING: The appliance and its accessible parts become hot during use. Care should be taken to avoid touching heating elements.
ENGLISH • • 6 box, remove the fuse to disconnect the appliance from power supply. In either case contact the Authorised Service Centre. If the supply cord is damaged, it must be replaced by the manufacturer, the Authorised Service Centre or similarly qualified persons in order to avoid a hazard.
ENGLISH • Before carrying out any operation make sure that the appliance is disconnected from the power supply. • Make sure that the parameters on the rating plate are compatible with the electrical ratings of the mains power supply. • Make sure the appliance is installed correctly. Loose and incorrect electricity mains cable or plug (if applicable) can make the terminal become too hot. • Use the correct electricity mains cable. • Do not let the electricity mains cable tangle.
ENGLISH • Used oil, that can contain food remnants, can cause fire at a lower temperature than oil used for the first time. • Do not put flammable products or items that are wet with flammable products in, near or on the appliance. Warning! Risk of damage to the appliance. • Do not keep hot cookware on the control panel. • Do not put a hot pan cover on the glass surface of the hob. • Do not let cookware boil dry. • Be careful not to let objects or cookware fall on the appliance. The surface can be damaged.
ENGLISH 9 780 mm 490±1 mm min. 500 mm 520 mm 750±1 mm min. 100 mm min. 38 mm min. 5 mm 55 mm max. R 5 mm 5 mm min. 38 mm Important! • For further information on the installation refer to the Assembly Instruction. • If there is no oven beneath the hob insert a dividing panel at a minimum distance of 20 mm from the bottom of the hob. • Do not use silicon sealant between the appliance and the worktop. Electrical connection Warning! Refer to Safety chapters.
ENGLISH 10 mains at all poles with a contact opening width of at least 3 mm, eg. automatic line protecting cut-out, earth leakage trips or fuse. • You must have the connection and the connecting links carried out as shown in the connection diagram (it is located on the underneath surface of the casing of the hob). The earth lead is connected to terminal marked with the symbol and must be longer than leads carrying electric current.
ENGLISH 11 Symbol Function Comment 1 ON / OFF 2 Lock / Child Safety Device To lock / unlock the control panel. 3 Pre-Set Cooking mode To activate and deactivate the function. Multi-Flexi mode To switch between three modes of the function. - Power setting display To show the power setting. - Timer indicators of cooking zones To show for which zone you set the time. - Timer display To show the time in minutes. 8 STOP+GO To activate and deactivate the function.
ENGLISH 12 Display Description Incorrect or too small cookware or no cookware on the cooking zone. Automatic Switch Off function operates. / / Pre-Set Cooking mode operates. Warning! There is a risk of burns from residual heat. directly in the bottom of the cookware. The glass ceramic is heated by the heat of the cookware. The induction cooking zones produce the heat necessary for the cooking process Daily use Warning! Refer to Safety chapters.
ENGLISH Using the Booster function The Booster function makes additional power available for the induction cooking zones. Touch to activate it, a lights up on the display. After maximum 10 minutes, the induction cooking zones automatically return to cooking level . Using the Timer Touch repeatedly until the indicator of a desired cooking zone flashes. For example for the front right zone. STOP+GO The function sets all cooking zones that operate to the lowest power setting .
ENGLISH 14 • Activate the appliance with . Do not set the power settings. Touch for 4 comes on. seconds. The symbol • Deactivate the appliance with . To override the Child Safety Device for only one cooking time • Activate the appliance with . The symbol comes on. for 4 seconds. Set the power • Touch setting in 10 seconds. You can operate the appliance. • When you deactivate the appliance with , the Child Safety Device operates again.
ENGLISH different size, or into one large cooking area. You choose the combination of the sections by choosing the mode applicable to the size of the cookware you want to use. There are three modes: Multi-Flexi mode 2 + 2 sections (activated automatically when you activate the hob), Multi-Flexi mode 3 + 1 sections and Multi-Flexi mode 4 sections. To set the power setting use two left side power selectors. Switching between the modes To switch between the modes use symbol: 100-160mm .
ENGLISH Correct cookware position: Correct cookware position: To use this mode you have to place the cookware on the three connected sections. If you use cookware smaller than two and after 2 sections the display shows minutes the zone deactivates. Incorrect cookware position: Incorrect cookware position: Multi-Flexi mode 3 + 1 sections To activate the mode press until you see the correct mode indicator. This mode connects three rear sections into one cooking zone.
ENGLISH 17 To set the power setting use one of the left side power selector. Correct cookware position: To use this mode you have to place the cookware on the four connected sections. If you use cookware smaller than three and after 2 sections the display shows minutes the zone deactivates. Pre-Set Cooking mode This function allows you to adjust the temperature by moving the cookware to a different position on the induction cooking area.
ENGLISH General information: • 160 mm is the minimum bottom diameter of the cookware for this function. • Power setting display for the left rear power selector shows the position of the cookware on the induction cooking area. Front , middle , rear . 18 You can change the power settings for each position separately. The hob will remember your power settings next time you activate the function. Activating the function To activate the function place the cookware in the correct position on the cooking area.
ENGLISH 19 Hints and tips Noises during operation When a cooking zone is active, it may hum briefly. This is a characteristic of all ceramic glass cooking zones and does not impair either the function or the life of the appliance. Cookware for induction cooking zones Use the induction cooking zones with correct cookware. Cookware material • correct: cast iron, steel, enamelled steel, stainless steel, the bottom made of multilayer (with correct mark from a manufacturer).
ENGLISH 20 Removing the residues and stubborn residues 1. Food containing sugar, plastics, tin foil residues should be removed at once, best tool for cleaning glass surface is a scraper (not included with the appliance). Place a scraper on the glass ceramic surface at an angle and remove residues by sliding the blade over the surface. Wipe the appliance with a damp cloth and a little washing up liquid. Finally, rub the appliance dry using a clean cloth. 2.
ENGLISH Problem The hob deactivates. 21 Possible cause You put something on the symbol Remedy Remove the object from the symbols. The power setting changes between two levels. Power exchange function operates. Refer to "Daily use" chapter. The symbols become hot. The cookware is too large or Put large cookware on the you put it too near to the rear zones if possible. controls. There is no signal when you touch a symbol on the control panel. The signals are deactivated. Activate the signals.
ENGLISH Problem 22 Possible cause Remedy The diameter of the bottom of the cookware is too small for the zone. Use cookware with correct dimensions. Refer to “Hints and tips” chapter. The cookware does not cover the cross / square. Cover the cross / square fully. Multi-Flexi mode operates. One or more sections of the function mode which operates are not covered by cookware. Place the cookware on the correct number of sections of the function mode which operates or change the function mode.
ENGLISH 23 If there is a fault, first try to find a solution to the problem yourself. If you cannot find a solution to the problem yourself, contact your dealer or the After Sales Service. If you operated the appliance wrongly, or the installation was not carried out by a registered engineer, the visit from the After Sales Service technician or dealer may not take place free of charge, even during the warranty period. Technical data Rating Plate Made in Germany © Inter IKEA Systems B.V.
ENGLISH 24 Lenght (L) and width (W) of Left the cooking area L 46.4 cm W 24.7 cm Energy consumption per cooking zone (EC electric cooking) Middle rear Right front 167.1 Wh / kg 177.5 Wh / kg Energy consumption of the cooking area (EC electric cooking) Left 184.
ENGLISH authorized service partner network. Contact IKEA for further information. If you encounter any trouble with the appliance and wish to register a service call or make a claim, please refer to www.ikea.com.au for your local store after sales customer service center phone number, online email and opening times.
ENGLISH • • • • • • • • • • age caused by excessive lime in the water supply, damage caused by abnormal environmental conditions. Consumable parts including batteries and lamps. Non-functional and decorative parts which do not affect normal use of the appliance, including any scratches and possible colour differences. Accidental damage caused by foreign objects including insect or vermin infestation or substances and cleaning or unblocking of filters, drainage systems or soap drawers.
ENGLISH 27 Please do not hesitate to contact the dedicated after sales customer service center for IKEA appliances to: SAVE THE SALES RECEIPT! Kindly keep all these details and original invoice of purchase handy during the service technician's visit to enable him to carry out the job. It is your proof of purchase and required for the guarantee to apply. Note that the receipt reports also the IKEA article name and number (8 digit code) for each of the appliances you have purchased. 1.
867328369-D-202019 © Inter IKEA Systems B.V.
