User manual

Problem Possible cause Solution
DEMO appears on the dis-
play.
The appliance is in demon-
stration mode.
Keep the Mode pressed for
approximately 10 seconds un-
til a long sound is heard and
display shuts off for a short
time.
The temperature in the ap-
pliance is too low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera-
ture.
The temperature in the ap-
pliance is too low/too high.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The temperature in the ap-
pliance is too low/too high.
The food products temper-
ature is too high.
Let the food products temper-
ature decrease to room tem-
perature before storage.
The temperature in the ap-
pliance is too low/too high.
Many food products were
inserted at the same time.
Insert less food products at the
same time.
The temperature in the ap-
pliance is too low/too high.
The door has been
opened too often.
Open the door only if necessa-
ry.
The temperature in the ap-
pliance is too low/too high.
The Fast Freezing function
is switched on.
Refer to "Fast Freezing func-
tion".
The temperature in the ap-
pliance is too low/too high.
The Shopping Function is
switched on.
Refer to "Shopping Function".
The temperature in the ap-
pliance is too low/too high.
There is no cold air circula-
tion in the appliance.
Make sure that there is cold
air circulation in the appliance.
Side panels of the appliance
are warm.
This is a normal state
caused by operation of the
heat exchanger.
Make sure that there is at least
30 mm of space between each
side of the appliance and the
surrounding furniture when the
ambient temperature exceeds
38°C.
There is too much con-
densed water on the rear
wall of the refrigerator.
Door was opened too fre-
quently.
Open the door only when nec-
essary.
There is too much con-
densed water on the rear
wall of the refrigerator.
Door was not closed com-
pletely.
Make sure the door is closed
completely.
ENGLISH 24