User manual

A B
C
D
E
• A - green and yellow: Earth
• C - brown: Live
• D - blue: Neutral
As the colours of the wires in the mains lead
of this appliance may not correspond with
the coloured markings identifying the
terminals in your plug, proceed as follows:
1. Connect the wire coloured green and
yellow to the terminal marked either
with the letter “E“ or by the earth symbol
or coloured green and yellow.
2. Connect the wire coloured blue to the
terminal either marked with the letter
“N“ or coloured black.
3. Connect the wire coloured brown to the
terminal either marked with the “L“ or
coloured red.
4. Check that no cut, or stray strands of
wire is present and the cord clamp (E) is
secure over the outer sheath.
Make sure the electricity supply voltage
is the same as that indicated on the
appliance rating plate.
5. Switch on the appliance.
The appliance is supplied with a 13 amp
fuse (B). In the event of having to change
the fuse in the plug supplied, a 13 amp
ASTA approved (BS 1362) fuse must be
used.
Warning! A cut off plug inserted
into a 13 amp socket is a serious
safety (shock) hazard. Ensure
that it is disposed of safely.
Installation of the Carbon air filter
The Carbon air filter is an active carbon
filter which absorbs bad odours and permits
to maintain the best flavour and aroma for
all foodstuffs without risk of odour cross
contamination.
On delivery the carbon filter is in a plastic
bag to maintain its duration and
characteristics. The filter should be placed
behind the flap before the appliance is
turned on.
1. Open the flap cover.
2. Remove the filter from the plastic bag.
3. Insert the filter in the slot found in the
back of the flap cover.
4. Close the flap cover.
ENGLISH
8