User Manual

18ENGLISH
Problem Possible Cause Solution
There is too much condensed
water on the rear wall of the
refrigerator.
Door was opened too frequently.
Open the door only when
necessary.
Door was not closed completely.
Make sure the door is closed
completely.
Stored food was not wrapped.
Wrap food in suitable packaging
before storing it in the appliance.

refrigerator.
The drain hole at the back of the
appliance is clogged.
Clean the drain hole with a piece
of wire.
Food products prevent water from

Make sure that food products do
not touch the rear plate.

The door is not closed well.
Refer to "Closing the door", or
refer to the troubleshooting item
below ("The door does not close
completely").
The appliance tilts forward.
Tilt the appliance slightly backward
(a quarter-inch lower in the back).
Refer to the separate Assembly
Instructions for appliance level
adjustment.
The drip pan cracks.
Contact Authorised Service Centre
listed at the end of this manual.
The defrost water drain is clogged.
Clean the drain hole with a piece
of wire.
The doors does not close
completely.
The shelves are out of position.
Make sure the shelves are in
correct position. Refer to "Movable
shelves".
The door gaskets are dirty. Clean the door gaskets.
The appliance is not level.
Make sure the appliances
is installed in level. Refer to
"Levelling feet", or the separate
Assembly Instructions
Malfunction alarm
If the appliance malfunctions, the LED indicators

and the buzzer will sound. To switch the buzzer

1
 button.
and 
Temperature sensor failure
of the refrigerator chamber
and 
Temperature sensor failure
of the freezer chamber
and 
Defrosting sensor failure of
the freezer chamber
and 
Communication failure
and 
Failure of ambient
temperature sensor
If your appliance still is not working
properly after making the above checks,
contact the Authorised Service Centre. You

Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to the
separate Assembly Instructions.
3. If necessary, replace the defective door
gaskets. Contact the After Sales Service.
Replacing the lamp
The appliance is equipped with a lamp for
interior lighting.