User Manual
12ENGLISH
Operation
Switching on
• Connect the mains plug to the power socket.
The display on the control panel turns on.
The temperature indicators show the set
default temperatures for the refrigerator
and the freezer compartments respectively.
• To change temperature, refer to the section
for temperature regulation.
When operating the
appliance
set the appliance at a colder temperature and
run it without loading any food until it auto
stops at the set temperature. Usually it takes
put food in the
appliance
.
Switching o
•
the
1
• To switch the appliance on, press and hold
the
1
To disconnect the appliance from the power
supply, disconnect the mains plug from the
power socket.
Temperature regulation for refrigerator
compartment
• Press the
2
Refrigerator temperature
button to toggle the
3
refrigerator
8˚C 4˚C 2˚C
• One ( ) on indicates °C is set.
• Two ( ) on indicate 4°C is set.
• Three ( ) on indicate 2°C is set.
Temperature regulation for freezer
compartment
• Press the
4
Freezer temperature button
to toggle the
5
freezer temperature
temperatures.
-16˚C -19˚C -24˚C
• One ( ) on indicates °C is set.
• Two ( ) on indicate -19°C is set.
• Three ( ) on indicate -24°C is set.
Adjust the temperature setting by keeping in
mind that the temperature inside the appliance
depends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance
Important! If the ambient temperature is
high or the appliance is fully loaded, and the
appliance is set to the lowest temperatures, it
may run continuously causing frost to form on
the rear wall. In this case a higher temperature
must be set to allow automatic defrosting and
therefore reduced energy consumption.
Door open alarm
If the door of the appliance is left open for two
minutes, the buzzer will sound continuously
close the door or press the
1
button.