User Guide

4. After the values have been changed, press the “Write” button.

5. If you turned off your motors previously, turn them back on before proceeding. Locate and press the

“1. Calib. El. Field” button. You should hear a series of beeping noises, while your gimbal motors will

automatically move. When the sound and gimbal stops, the calibration is finished.

6. Next, we’ll need to calibrate the offset. The calibration process is different on this depending if you

have a straight arm or angled arm gimbal.

a. Straight Arm Gimbal

i. Place the gimbal on a flat level surface.

ii. Either manually or with the joystick, align the back motor arm with the LCD display.

iii. Press the “2. Calib Offset” button

b. Angled Arm Gimbal

i. Either manually or with the joystick, align the back motor arm with the LCD display.

ii. Tilt the gimbal forward so that the back motor is perpendicular to the flat surface.

Make sure that the back motor arm is still aligned with the LCD display after tilting

forward.

iii. Press the “2.Calib Offset” button