User Manual

▲
Camera Installation and Balance
10 2016 Beholder ® All Right Reserved
Instructions to install the camera
STEP 1
Mount the camera quick release
• Remove the quick release plate from the gimbal.
• Attach the quick release plate to the camera (Fig. 4). Be careful not to twist it too tight at this point.
• Make sure the quick release plate direction is facing forward toward the lens.
Fig. 4. The camera is attached to the quick release plate
WARNING
Before installing the camera and adjusting the balance, remove the camera lens cover, attach
the lens hood, and insert a memory card and camera batteries, as well as any other
accessories. The camera should be fully ready to shoot.