User guide
- 77 -
&RUQLQJS+ LRQPHW H U
pH meter for two independent measuring points with temperature compensation.
0HDVXUHGYDOXHV
1. pH value measuring sensor A
2. pH value measuring sensor B
3. Compensation temperature in °C
127(
Detailed information on the instrument features may be found in the separate operating manual.
For proper communication the transmission parameters of the unit serial interface have to be set to
the following values:
%DXGUDWH%DXG
In addition, the
6\VWHP_'DWDORJJHU
function must be set to
RQSULQWRQO\
.
The response times of this device is 2200 ms for each activated measured value. If all outputs are
activated then the minimum possible measuring rate increases to 6600 ms. If a lower scanning rate
has been selected by the user, then it is automatically corrected when the measurement is started
with
ODEZRUOG
VRIW.