User guide

- 50 -
0RQRIORS&RQWURO%ORFN
The 0RQRIORS control block is a WLPHUZKLFKLVWULJJHUDEOHVWDUWDEOHYLDDFRQWUROLQSXWIf a
change of the logic level from TTL-Low to TTL-High arises at the control input (
3RVLWLYH6ORSH
) or
the opposite (
1HJDWLYH6ORSH
), the level of the output for the
+ROG7LPH
is switched.
The level of the output signal depends on the /HYHOIRU+ROG7LPH setting. If +LJK is selected, the
level is in the untriggered state TTL-Low, and during the hold time TTL-High; if
/RZ
is selected,
the level is in the untriggered state TTL-High, and changes during the hold time to TTL-Low.
If the
5HWULJJHULQJ
option is activated, a new trigger pulse leads to a new start of the hold time; i.
e. if the hold time is greater than the spacing of the trigger pulse, the output remains permanently
set. In this way, it is possible, for example, to monitor a periodically occurring signal.
If
5HWULJJHULQJ
is not activated, incoming trigger pulses are ignored during the
+ROG7LPH
. The
Monoflop can first be retriggered after expiration of the
+ROG7LPH
.
Carry out the following instructions:
1. Call up the parameters window by double clicking on the icon.
2. If necessary, enter the
0RGXOH1DPH
of the control block into the "Designation" text field.
3. Select
7ULJJHU
on
3RVLWLYH
or
1HJDWLYH6ORSHV
4. Enter
+ROG7LPH
.
5. Select
+ROG7LPH/HYHO
.
6. Select
5HWULJJHULQJ
if required.

 0XOW LFKDQQHO2SHUDWLRQ
The ports should identifiable for multichannel operation. The ports may be identified for this
purpose.
Carry out the following instructions:
1. Set the
&KDQQHO&RXQW
by clicking the upper arrow keys.
2. Select the channel by clicking the lower arrow keys.
3. Enter the
&KDQQHO'HVLJQDWLRQ
into the text field, i.e. make an entry for each channel
selected.
4. Select
7ULJJHU
on
3RVLWLYH
or
1HJDWLYH6ORSHV
5. Enter
+ROG7LPH
.
6. Select
7ULJJHU
on
3RVLWLYH
or
1HJDWLYH6ORSHV
7. Enter
+ROG7LPH
.
8. Confirm entries with
2.
.