Owner manual

ManualsBrandsIKA ManualsEquipmentKS 130 control

Error code

Error Cause of the error

Off - LED (red) The potentiometer for -Too rapid a change in the

1x flash / the speed is not assig- speed target value

2 sec pause ning any target value -Internal device error

Off - LED (red) Permissible motor tem- -Permissible supported

2x flash / peratur exceeded weight exceeded

2 sec pause -Permissible ambient

temperature exceeded

Motor locked -Agitation table is being

hindered in this stroke mo-

tion by an outside effect

Read fork signal not -Internal device error

available

Off - LED (red) Maximum adjustable -Resonance behavior of

3x flash / speed of the device the experiment setup

2 sec pause exceeded

Off - LED (red) Motor standstill for de- -When turning on the

4x flash / vice switch-on proce- device, you must ensure

2 sec pause dure (safety confirma- that the motor is not

tion not ensured performing any rotational

motion

Off - LED (red) Safety relay cannot -Internal device error

5x flash / be activated

2 sec pause

Off - LED (red) The switch for the TIME -Internal device error

6x flash / function is not assigning

2 sec pause any target value

Off - LED (red) Problem with the power -The device is beeing

7x flash / supply operating with under vol-

2 sec pause tage or overvoltage (for

permissible voltage range,

see technical data)

Off - LED (red) Triac cannot be activated -Internal device error

8x flash /

2 sec pause

032007

place evenly on the agitation table, and that all vessels are secu-

rely fastened in place.

Basic error codes:

ATTENTION! If an error code is encountered, an audio warning

signal is generated and the red Off signal light goes on in the dis-

play field. First, please try to continue operation by turning the

device off and back on again.If it is still not possible to eliminate

an error after an extended wait, please contact our service

department. If you do so, you should always tell us what error

code has been encountered. This simplifies the process of

tracking down the error and makes it possible to form a prelimi-

nary opinion.

AS 130.1 Universal attachment

AS 130.4 Reactant glass adapter

1/min

0 80 560

160

240 320 400 480 640 800720

2000

1750

1500

1000

500

1250

750

250