Manual

- glass breakage as a result of mechanical shaking power
- incorrect container size
- too much medium
- unsafe condition of container
• Only process media that will not react dangerously to the extra
energy produced through processing. This also applies to any
extra energy produced in other ways, e.g. through light irradiation.
• Do not operate the appliance in explosive atmospheres, with
hazardous substances or under water.
• A seperation from the line is made with the equipment only by
pulling net and/or device plug.
• Safe operation is only guaranteed with the accessories described
in the ”Accessories” chapter.
• Always disconnect the plug before fitting accessories.
• Accessories must be securely attached to the device and cannot
come off by themselves. The centre of gravity of the assembly
must lie within the the set-up surface.
• The appliance starts up again automatically following a cut in the
power supply.
• The appliance may heat up when in use.
• Abrasion of the dispersion equipment or the rotating accessories
can get into the medium you are working on.
To the protection of the equipment
• The voltage stated on the nameplate must correspond to the
mains voltage.
• Do not cover the device, even partially e.g. with metallic plates
or film. This results in overheating.
• Protect the appliance and accessories from bumps and impacts.
• Observe the minimum distances between devices, between the
device and the wall as given in the Fig. 2 and above the assem-
bly (min. 800mm)
4
CMAG 012014
> 100 mm > 100 mm
> 100 mm
• Unpack
- Please unpack the device carefully
- In the case of any damage a fact report must be set
immediately (post, rail or forwarder)
•
Delivery scope
- Heating magnetic stirrer or
Magnetic stirrer or
Heating device
- Mains cable
- Operating instructions
•
Use
-
For mixing and/or heating liquids
•
Range of use
- Laboratories - Schools
- Chemical industry - Pharmacies
Unpack
Correct use
Fig. 2