Instruction Manual

0HVVDJHVDQG7URXEOHVKRRWLQJ
I
KA

-WERKE C 7000 Ver. 07 09.07
3DJH
0
HVVDJH &DXVH 5HPHG\
QRLQFUHDVHLQWHPSHUDWXUH
12 seconds after the start of the
m
ain test, the temperature
increase is less than 0.2 K.
Faulty ignition or vessel not filled
with oxygen.
Open vessel and check these points.
If the sample has burnt, the sample
was too small. Then increase size of
sample.
PHDVXUHPHQWUDQJH
H[FHHGHG
During a measurement, the
permissible temperature has
been exceeded.
Contacts of the decomposition
vessel (contact board) or the
calorimeters (contact pins) dirty
or damaged.
Measurement PCB defective.
Reduce mass of sample.
Clean contacts, if damaged inform
Technical Service Department.
Inform Technical Service
Department.
PHDVXUHPHQWFDUG
GHIHFWLYH
Hardware fault on measurement
PCB
Inform Technical Service
Department.
PHDVXUHPHQWDOUHDG\
SHUIRUPHG
A sample code has been entered
for which a temperature increase
is already stored (by
measurement or manually).
Enter sample code that has not yet
been used.
0HDVXUHPHQWVWDUWHG
This indicates the start of a
measurement.
SRVWWHVWSDUDPHWHUV
DOUHDG\HQWHUHG
Under this sample code, post-
test parameters are already
entered.
To change parameters, you can use
sub-menu HGLW in PHQX.
QRPHDVXUHPHQW
SHUIRUPHG\HW
Post-test parameters can only be
entered after a test has been
made.
First carry out measurement or enter
temperature increase manually.
VDPSOHFRGHLVDVVLJQHG
Under this sample code,
parameters are already entered.
Enter sample code that has not yet
been used.
VDPSOHFRGHQRWIRXQG
The sample code entered could
not be found.
Enter valid sample code.
PHPRU\IRUWHVWVIXOO
The available memory is full
(100 tests).
Erase tests no longer needed
(PHQX, sub-menuGHO).