Instruction Manual

(YDOXDWLRQRI&DORULILF9DOXH7HVWV
I
KA

-WERKE C 7000 Ver. 07 09.07
3DJH
K\JU
PRLVWXUHDQ Percentage of water from hygroscopic moisture
Calculation modes: FRDOWFRDOW
VXOSKXUDQ P
ercentage of sulphur
Calculation mode: FRDOW
 7HVWVLPXODWLRQ
In some cases, it is helpful to run through calorific-value tests or to calculate possi-
b
le test results without actually carrying out a combustion test. Under PHQX  
PDQXDOPHDVXUH you can enter the temperature increase of a test manually.
This is especially useful if a calibration has been accidentally carried out instead of a
calorific-value determination or vice versa. By using the measured temperature in-
crease, a misinterpreted measurement can be corrected by simulation.
To enter a temperature increase for a particular test, proceed as follows:
c
In PHQX, enter the pre-test parameters (SUHSDU) for the test.
d
From PHQX, go to the sub-menu PDQXDO, and from there to sub-menu PHDVXUH.
You will be asked for the VDPSOHFRGHV.
e
Use the alpha-numeric keys to enter the code for the test that is to be simulated,
and then press the ↵ button. The LCD-display shows the enquiry LQFUHDVHLQWHP
SHUDWXUH.
f
Use the number keys to enter the required temperature increase, and then press the
↵ button. The enquiry ERPEQR appears in the LCD-display.
g
Use the number keys to enter the number of the decomposition vessel, and then
press the ↵ button. In the second line of the LCD-display, the enquiry PHP VDYH
appears briefly. After it has disappeared, pressing the PHP button stores the data
entered. The green LED near the 9EXWWRQ blinks to indicate the end of the simu-
lated test. Acknowledge this with the 9EXWWRQ, and exit this program.