Instruction Manual
IKA
-
WERKE C 7000 Ver. 07 09.07
3DJH
a
s delivered condition are marked "raw", and parameters that refer to the analyti-
cally moist condition are indicated by "an".
By calling up the sub-menu DIWHUS under PHQX, the various parameters can be
entered in order in the same way as the pre-test parameters (see Section 7.3). The
values entered must be stored by pressing the PHP button. After they have been
stored, the data can only be changed by using the HGLW menu. However, the post-
test parameters can only be changed after the test has been either printed or shown
on the LCD-display.
The meanings of the parameters and the calculation modes to which they belong
are given in the following list:
VDPSOHFRGH The sample code is the means of identifying a test. Use of this
code word gives access to the test data.
Applies to all calculation modes.
UHPDUN F
or documentation purposes, a text of up to 10 characters can
be entered.
Applies to all calculation modes.
TH[WU F
or entering any desired external energy for calculation of
gross and net calorific values.
Applies to all calculation modes.
WRWDO+
2 Percentage of total water in the combustion sample as deter-
mined by element analysis.
Calculation mode: VWGW
K\GURJHQDQ P
ercentage of total water in the combustion sample.
Calculation modes: VWGWFRDOWFRDOW
1D
&2 YRUJ Amount of sodium carbonate solution placed in the decompo-
sition vessel (according to DIN: 20 ml; 0.05 N).
Calculation modes: VWGWFRDOW
%D2+
YHUEU Titrated quantity of 0.1 N barium hydroxide solution (titration of
the distilled water used to rinse the decomposition vessel after
a test).
Calculation modes: VWGWFRDOW
+&OYHUEU T
itrated quantity of 0.1 N hydrochloric acid (titration of the dis-
tilled water used to rinse the decomposition vessel after a
test).
Calculation modes: VWGWFRDOW
JUPRLVWXUHUDZ P
ercentage of water from rough moisture.
Calculation modes: FRDOWFRDOW
DVKDQ P
ercentage of ash.
Calculation modes: FRDOWFRDOW
3RVWWHVW
SDUDPHWHUV