Instruction Manual

&RPPLVVLRQLQJ
I
KA

-WERKE C 7000 Ver. 07 09.07
3DJH
e
U
se function key I to call up the sub-menu UHDOW; by doing so you have reached the
lowest Level of the menu structure. The LCD-display is now prepared for entering
the time interval for output of readings during a test. The value currently set is
shown in the left-hand zone of the second line of the LCD-display, and the values
that can be selected, 0, 3, 12 and 24 seconds, are given in the right-hand zone.
f
Use one of the function keys I, I, I or I to select the desired value. Your choice
is then shown in the left-hand zone of the second line of the LCD-display.
g
Confirm with the ↵ button. In the second line, the request PHP  VDYH appears.
Wait until the request disappears again.
h
Then press the PHP button to store your new entry. With the HVF button, you can
now go back to PHQX in the main menu. If you do not want to store the new time
interval, press the HVF button without first using the PHP button. That will take you
back to PHQXin the main menu without accepting the newly entered time interval.
&RQILJXUDWLRQIRUDEDODQFH
From the menu-structure diagram in Section 6.4, you can see that, to configure for a
balance, you need sub-menu +',QLW of main menu PHQX. To configure for a bal-
ance, proceed as follows:
c
Operate the button

once, or press twice. PHQXappears in the LCD-display.
d
Press the function key I to go to sub-menu +',QLW. The system parameters for
hardware initialization appear in the LCD-display.
r e a l t i m e p r i n t o u t
0 3 1
2 2 4
I

I

I

I

S T I n i t
1 2
m e n u 3
H D I n i t S T I n i t I G N t i m e
I

I

I

1
2 : 0 0 : 0 0
h a r d w a r e i n i t i a l i z a t i o n
e
x t . P C b a l a n c e d a t e t i m e
I

I

I

I

H D I n i t