Instruction Manual

&RPPLVVLRQLQJ
I
KA

-WERKE C 7000 Ver. 07 09.07
3DJH
 6ZLWFKLQJWKHV\VWHPRQ
When the mains switch is switched on, an introductory screen appears with the fol-
l
owing text:
The letters VX.X give the software version installed in the instrument.
After a short pause, the display changes to the main menu, PHQX.
If there is no printer connected, an acoustic signal sounds for a few seconds,
and a green LED near the button on the key panel blinks (please see the next
section for a description of this button). Acknowledge the signal by pressing this
button, and the signal tone and blinking will be switched off.
6ZLWFKLQJRQWKH&FRROHU
The C 7002 cooler is switched on at its main switch, which is on the rear face of the
unit. When it is switched on, the display shows three horizontal lines. Make sure the
water supply is turned on and adequate for a flow rate of 1 to 2 litre/min.
 'LVS OD\DQGFRQWUROHOHPHQWV
The calorimeter is operated from a membrane-type key pad specially designed for
l
aboratory use.
An LCD display shows system data, test data, and menus and dialog windows for
entering data. It has two lines of 40 characters each, and is divided into 4 zones:
=RQHVRI
/&'GLVSOD\
m e n u 1
p r e - p a r a f t e r - p . o u t p u t d e l .
1
2 : 0 0 : 0 0



1 Info/explanations
2 Time/sub-menus
3 Entry field
4 Texts for function buttons

,QWURGXFWRU\
VFUHHQ
0DLQPHQX
PHQX
☞
m e n u 1
p r e - p a r a f t e r - p . o u t p u t d e l .
1
2 : 0 0 : 0 0
* * * * * I K A - W E R K E * * * *
*
* * * c a l o r i m e t e r s y s t e m C 7 0 0 0 V X . X * * * *