Manual

&DUHDQGPDLQWHQDQFH

IKA



-WERKE C 2000 basic / control Ver. 04 08.07

3DJH

Loosen the cylinder screws with a straight-bladed screwdriver.

Remove the centering ring together with the filling head, pressure spring and piston.

Be careful with the O rings that are now loose.

Push the pressure spring onto the new piston or replace the seal washer and insert

both parts into the filling head.

The remainder of the assembly is the same as disassembly in reverse order.

Please note: When reassembling the pieces, make certain the position of

the filling head is correct. The seals must be aligned with the

opposite side of the inner cover.

$IWHU UHDVVHPEO\FKHFNWKHVHDORIWKHV\VWHPZLWKWKH2

ILOOLWHPLQWKH0DLQ

WHQDQFHPHQX

,I WKH DVVHPEO\ ZDV SHUIRUPHG FRUUHFWO\ \RX ZLOO KHDU RQO\ D EUL HI KLVVLQJ

QRLVH

 'HFRPSRVLWLRQYHVVHOV

2QPDLQWHQDQFHRIGHFRPSRVLWLRQYHVVHOVUHDGWKH&&2SHUDWLQJ

,QVWUXFWLRQV

 1RWHVRQFOHDQLQJ

When cleaning IKA



devices, use only these cleaning agents that are approved by

IKA



7\SHRIGLUW                &OHDQLQJDJHQW

• Paint Isopropanol

• Construction materials Water with detergent, isopropanol

• Cosmetics Water with detergent, isopropanol

• Food Water with detergent

• Fuels Water with detergent

• Substances not named Please inquire with IKA



1RWH

Electrical devices must not be placed in the cleaning agent for cleaning purposes.

Stainless steel parts can be cleaned with standard commercial stainless steel

cleaning agents, but abrasive agents must not be used.

We also recommend that you wear gloves while cleaning.

The operator is responsible for performing appropriate decontamination measures if

hazardous materials have been spilled on or in the device.

Before using another cleaning or decontamination method than the one recom-

mended by the manufacturer, the user must verify with the manufacturer that the

intended method will not damage or destroy the device.

If the power supply cord is replaced, one of comparable quality should be used.