Manual
IKA
-WERKE C 2000 basic / control Ver. 04 08.07
3-1
3DJH
7UDQVSRUWDWLRQVWRUDJHDQGVHWXSORFDWLRQ
7UDQVSRUWDWLRQDQGVWRUDJHUHTXLUHPHQWV
During transportation and storage, the system must be protected against mechani-
cal jarring, vibrations, accumulations of dust and corrosive ambient air. Care should
also be taken so that the relative humidity does not exceed 80%.
The device must be completely emptied before being stored and transported.
In case of repair the device has to be cleaned and free from any materials which
may constitute a health hazard.
If you require servicing, return the appliance in its original packaging. Storage pack-
aging is not sufficient. Please also use suitable transport packaging.
6HWXSORFDWLRQ
When setting up the device, make certain that the applicable state regulations for
operating pressurized containers are adhered to.
A constant ambient temperature is an important prerequisite in ensuring the high
measurement precision of the system. The following conditions must therefore be
maintained at the set-up location:
• No direct sunlight.
• No drafts (for example next to windows, doors, air conditioner outlets).
• The device must be at a sufficient distance from heater and other sources of
heat.
• The minimum distance between the wall and the rear side of the device must be
at least 25 cm.
• The system must not have laboratory hardware such as shelves, wire ducts,
ring lines, etc. installed above it.
• The room temperature must be in the range of 20 °C ... 25 °C (constant).
• The system must be set up on a horizontal surface.
A power supply corresponding to the rating plates of the system components and
the oxygen supply (99.95% pure oxygen, quality 3.5; pressure 30 bar, with a pres-
sure display) must be available to operate the system at the set-up location. A shut-
off valve for the oxygen supply must be installed. Observe the instructions on han-
dling oxygen given in Section 1 "For your safety”.