Owner's manual

3
Contents
Page
CE - Declaration of Conformity 02
Explication of warning symbols 02
User notes 02
Contents 03
Safety instructions 04
Correct use 05
System properties 05
Transportation, Storage 06
Transport and Storage conditions 06
Unpacking 06
Scope of delivery 06
Description of the system components 06
Hoses 07
Commissioning 07
Place of installation 07
Cooler connection 08
Venting hose connection 08
Drain hose connection 08
Oxygen supply connection 08
Power supply unit connection 09
Connection of peripherals 09
Handling the unit 09
Control unit with display 10
Dialog box 11
System start 12
Switching on the system (in the open state) 12
Selection of language 12
Pressure test 13
Oxygen pressure 13
System check 13
Heating detected 14
Factory settings 14
Calorimetric measurements 14
Determination of gross calorific value 14
Corrections 15
Notes on the sample 15
Complete combustion 16
Calibration 16
Notes on calibration 16
Overview Main menu 17
Measurements 17
Default settings 17
Settings 17
Maintenance 18
Informations 18
Preparing and performing measurements 18
Performing the measurement 18
Placing the sample 19
Preparing a measurement 19
Close the calorimeter 20
Prerequisite checking for a measurement 20
Measurement procedure 21
Cleaning the inner vessel 23
Follow-up measurement 23
Display the storage overview 23
Use of a disposable crucible 23
Using a scale 24
Permissible weight entries 24
Cancel a measurement 25
Page
Measurements 25
New measurements 25
Last result 25
System test 26
Measurement archiv 26
Measurement archive: Edit 27
Measurement archive: Print 27
Measurement archive: Delete 27
Measurement archive: Delete all 28
Calibration archiv 28
Calibration archiv: Edit 28
Calibration archiv: C-Value selectin 29
Calibration archiv: Print 29
Calibration archiv: Delete 29
Default settings 30
Settings 30
Date / Time 30
Units 30
Display / Keypad 31
Inverted menu view 31
List view 31
Language 31
Accessories 32
Chiller test 32
Maintenance 32
Maintenance menu 32
Change seal 33
Stirrer test 33
O2 System blow 33
Servo up 33
Servo down 33
Informations 33
User information: Memory 34
Prior to input a new measurement 34
After input a new measurement 34
Exchanging off wear parts 34
O2 Valve seal change 34
Change ignition wire 35
Change ignition electrode 35
Change the main seal 35
Change ground electrode 36
Leak test with the system test 36
Fault and troubleshoot 36
E01 STIRRER 36
E02 COMMUNICATION 37
E03 DRIFT ALARM 37
E04 MINTEMPDIFF 37
E05 FILLWATER 37
E06 EMPTYWATER 38
E07 POSTWATERFILLING 38
E10 FILLWATER SENSOR 38
E11 SYSTEM OPEN 38
E12 PRESSURE 38
E13 HEATER 39
E16 MAXTEMPDIFF 39
Accessories and Consumables 39
Maintenance 40
Warranty 40
Technical data 40
C1 092014