Data Sheet
Ikalogic | SP209 series data sheet | 7
software and provided drivers. It is
recommended to restart your computer
after the software and drivers have been
installed.
Once the software is installed, run it, and
create a new workspace by selecting
“SP209” or “SP209i” as the device type.
Note: if at the point the device is not
recognised by your computer, the
ScanaStudio workspace is created as a
demo workspace or the status LEDs stays
orange even after creating a ScanaStudio
workspace, please follow those steps:
● Ensure the USB port used can
deliver at least 500mA.
● Try switching to another machine
if one is available.
● If all the above fails, please contact
Ikalogic support.
Capturing your first signal
To capture your first logic signals, please
follow those steps:
1. Connect the device via USB
2. Launch ScanaStudio and create an
SP209(i) workspace.
3. Connect the probes to SP209(i)
and to your signals source
4. Ensure the ground probe is
connected
5. Check if the status LED is blinking:
if it’s the case, it means the some
logic changes are already being
detected on the probes.
6. Hit the start button in ScanaStudio
and wait until signals are captured.
You can adjust the quantity of samples to
capture by adjusting the number of
samples in the device configuration tab.
Mechanical data
All SP209 series devices casing are
manufactured from anodized aluminum,
able to withstand heavy duty usage in
various harsh environments. All markings
are laser engraved, ensuring important
pinout information is not lost over time.
Model SP209i
Weight: 105 gm
(All dimensions in mm)
Model SP209
Weight: 90 gm (preliminary)
(All dimensions in mm)