Data Sheet

Ikalogic | IkaScope WS200 data sheet | 6
When both IkaScope and the application     
are correctly connected, the connection    
icon should be green as in the following       
screenshot.

Note: IkaScope device must be turned ON to       
be connected to a network. If all LEDs are        
switched OFF, please turn ON IkaScope by      
pressing on the probe tip for 1 second.
Finally, press IkaScope probe tip on the      
pad where an electric signal needs to be       
measured. You should hear a “click”     
sound, and feel a vibration in the device:       
This means that data is being streamed to       
the application. Keep the pressure on the      
tip until you see signals appearing in the       
application (This can take between 100     
and 800 milliseconds).
Mechanical data
Weight: 60 gm (2.12 ounces)
Dimensions:

Safety information
Keep away from children’s sight. Do not      
expose to water, heat or moisture. Do not       
point probe tip toward body parts. Use      
only to measure electrical signals within     
±40 Volts range. Do not use in a system in         
which the failure of the product might      
result in personal injury. Only recharge     
from a USB port. Please read/refer to the       
knowledge base section on ikalogic.com    
for more information.
Certifications and regulations
IkaScope WS200 complies with the
following regulations
● FCC
● CE
● ROHS
● REACH
● WEEE
IkaScope contains a lithium battery. Both
the product and the battery were tested
according to:
● PI965 AIR
● PI965 SEA
● PI967 AIR
● PI967 SEA
● UN38.3
IkaScope contains a Wifi module that
complies with following regulations
● CE
● FCC
● GITEKI
● KCC
All test certificates can be provided upon
request.
