User Manual
Table Of Contents
- English
- Contents
- Power adapter information
- iRig Stomp I/O
- Register your iRig Stomp I/O
- 1 Installation and setup
- 2 Operating modes
- 3 Live Mode
- 4 Audio/MIDI interface and foot controller
- 5 Stand alone MIDI foot controller
- 6 Pedal calibration
- 7 External pedal inputs
- 8 Audio meters
- 9 Bootloader
- 10 Specifications
- Warranty
- Support and more info
- Regulatory
- 日本語
English
8
1.2 MAC/PC
1. Connect the USB cable to the iRig Stomp I/O port and to a free USB port on your MAC/PC (the required
power is supplied by the USB host).
2. Download and launch the AmpliTube App.
3. Connect a microphone or an instrument to the input combo jack. If the microphone you are using requires
external phantom power, activate the 48V switch. Adjust the input level with the gain potentiometer.
4. Connect a mixer, an amplifier or a PA system to the stereo line outputs. It is possible to control the output
volume with the Volume potentiometer on the top panel.
5. Connect your headphones to the headphone output. It is possible to control the output volume with the
Volume potentiometer on the top panel.
6. If needed, connect up to two footswitch/expression pedals to the TRS connector on iRig Stomp I/O.
7. If needed, you connect external MIDI devices to the physical MIDI ports (Input/Output).