User Manual
Table Of Contents
- English
- Contents
- Power adapter information
- iRig Stomp I/O
- Register your iRig Stomp I/O
- 1 Installation and setup
- 2 Operating modes
- 3 Live Mode
- 4 Audio/MIDI interface and foot controller
- 5 Stand alone MIDI foot controller
- 6 Pedal calibration
- 7 External pedal inputs
- 8 Audio meters
- 9 Bootloader
- 10 Specifications
- Warranty
- Support and more info
- Regulatory
- 日本語
English
6
4. Adjust the input level with the gain potentiometer.
5. Connect a mixer, an amplifier or a PA system to the stereo line outputs. It is possible to control the output
volume with the Volume potentiometer on the top panel. These are floating balanced output. This kind of
output approximately simulates a floating transformer winding; if both hot and cold outputs are driving signal
lines, then the outputs are balanced, as if a centre- tapped output transformer were being used. This system
has the advantage that it can give the same level into either a balanced or unbalanced input without rewiring
connectors. These kind of outputs are also perfect to route the onstage signal to a mixer without the need of
a DI box, ensuring a loud and pristine signal.