User Manual
Table Of Contents
- English
- Contents
- Power adapter information
- iRig Stomp I/O
- Register your iRig Stomp I/O
- 1 Installation and setup
- 2 Operating modes
- 3 Live Mode
- 4 Audio/MIDI interface and foot controller
- 5 Stand alone MIDI foot controller
- 6 Pedal calibration
- 7 External pedal inputs
- 8 Audio meters
- 9 Bootloader
- 10 Specifications
- Warranty
- Support and more info
- Regulatory
- 日本語
English
10
3 Live Mode
3.1 Using iRig Stomp I/O with AmpliTube
When connected to a device running AmpliTube you can access to a full set of controls. Below we describe the
operational mode when the app/software AmpliTube is running.
USB MIDI port
Make sure to have selected “iRig Stomp IO Control” as MIDI IN/OUT port.
3.2 Preset mode
Switch combination Function MIDI message sent
Pressing Switch 3+4 >1sec. Stomp Mode/Preset Mode CC#39 val 0
MIDI CH 1
The iRig Stomp I/O has two main modes: Preset and Stomp. To switch between the two, simply press
simultaneously footswitches 3 and 4 for more than 1 second. When in Stomp mode, the LED on the top panel
will light up red.
Launch AmpliTube and tap on the LIVE section: