User's Manual
Table Of Contents
- Contents
- Introduction
- 1 – Installation and Setup
- 2 – Turning The Unit On/Off - Calibration Process
- 3 – Overview
- 4 – Front Panel Interface
- 4.1 – Home Display
- 4.2 – Sound Editing Matrix
- 4.2.1 – Oscillators (OSC)
- 4.2.2 - Mixer (MIX)
- 4.2.3 – Filters (FILTER)
- 4.1.4 – LFOs (LFO)
- 4.2.5 – Envelopes (FILTER ENV - AMP ENV)
- 4.2.6 – Modulation Matrix (MATRIX)
- 4.2.6 – Effects (FX)
- 4.2.7 – Effects Type List And Parameters
- 4.2.8 – Other Sound Editing Shortcuts
- 5 – Global Controls
- 5.1 – Presets
- 5.1.1 – The Edit Preset Menu
- 5.1.2 - Store a Preset
- 5.1.3 – Recall Preset
- 5.1.4 – Rename Preset
- 5.1.5 – Initialize A Preset
- 5.1.6 – Compare Preset
- 5.1.7 – Demo
- 5.2 – Setup
- 5.2.1 – Master Tuning
- 5.2.2 – MIDI
- 5.2.3 – Sync
- 5.2.4 – Keyboard
- 5.3 – Song
- 5.4 – Arpeggiator
- 5.5 – Sequencer
- 5.5.1 – ALT(ernative) Editing button
- 5.6 – Voice Mode: Assign System
- 6 – FAQ and Troubleshooting
- 7 – Support
UNO Synth Pro
4 – Front Panel Interface
20
MODULATION SOURCES MODULATION DESTINATIONS
Velocity OFF
Mod Wheel Osc 1 Tune
Aftertouch Osc 1 Wave
Key Pitch Osc 1 Level
Key Gate Osc 2 Tune
Osc 1 Tune Osc 2 Wave
Osc 1 Level Osc 2 Level
Osc 2 Tune Osc 2 FM Amount
Osc 2 Tune Osc 3 Tune
Osc 3 Tune Osc 3 Wave
Osc 3 Level Osc 3 Level
Noise Osc 3 FM Amount
Filter 1 Cuto
Noise level
Filter 1 Res Filter 1 Cuto
Filter 2 Cuto Filter 1 Res
Filter 2 Res Filter 2 Cuto
Filter Spacing Filter 2 Res
LFO 1 Filter Spacing
LFO 1 Fade In LFO 1 Wave
LFO 2 LFO 1 Rate
LFO 2 Fade in LFO 2 Wave
Filter Env LFO 2 Rate
Amp Env Filter 1 Env Amount
CV 1 IN Filter 2 Env Amount
GATE 1 IN Amp Env Amount
CV 2 IN Drive Amount
GATE 2 IN Delay Amount
Accent Reverb Amount
Gate Mod Amount
Tie CV OUT 1
GATE OUT 1
CV OUT 2
GATE OUT 2
Accent Amount
Mod N1-16 Amounts
CV (control voltage)
CV input is bipolar (where value 64 is +2.5V).
CV output is unipolar (positive range only from 0 to +5V).