User's Manual
Table Of Contents
- Contents
- Introduction
- 1 – Installation and Setup
- 2 – Turning The Unit On/Off - Calibration Process
- 3 – Overview
- 4 – Front Panel Interface
- 4.1 – Home Display
- 4.2 – Sound Editing Matrix
- 4.2.1 – Oscillators (OSC)
- 4.2.2 - Mixer (MIX)
- 4.2.3 – Filters (FILTER)
- 4.1.4 – LFOs (LFO)
- 4.2.5 – Envelopes (FILTER ENV - AMP ENV)
- 4.2.6 – Modulation Matrix (MATRIX)
- 4.2.6 – Effects (FX)
- 4.2.7 – Effects Type List And Parameters
- 4.2.8 – Other Sound Editing Shortcuts
- 5 – Global Controls
- 5.1 – Presets
- 5.1.1 – The Edit Preset Menu
- 5.1.2 - Store a Preset
- 5.1.3 – Recall Preset
- 5.1.4 – Rename Preset
- 5.1.5 – Initialize A Preset
- 5.1.6 – Compare Preset
- 5.1.7 – Demo
- 5.2 – Setup
- 5.2.1 – Master Tuning
- 5.2.2 – MIDI
- 5.2.3 – Sync
- 5.2.4 – Keyboard
- 5.3 – Song
- 5.4 – Arpeggiator
- 5.5 – Sequencer
- 5.5.1 – ALT(ernative) Editing button
- 5.6 – Voice Mode: Assign System
- 6 – FAQ and Troubleshooting
- 7 – Support
UNO Synth Pro
4 – Front Panel Interface
15
The Spacing control is a fixed modulation route like the Envelope Amount to Filter control.
MODE: Depending on the selected filter, selects the mode, slope and routing of the two filters using as
following:
FILTER 1:
• 2P LP 0°
• 2P LP 180°
• 2P HP 0°
• 2P HP 180°
• BYPASS
FILTER 2
• 2P LP SERIAL
• 4P LP SERIAL
• 2P LP PARALLEL
• 4P LP PARALLEL
• BYPASS SERIAL
• BYPASS PARALLEL
Other parameters are accessible from the EDIT PRESET menu.
LINK: This control has 3 status:
• OFF
• CUTOFF, which links only the Cutoff frequencies of the filters
• CUTOFF + RES, which links both cutoff and resonance of the filters
When this parameter is in CUTOFF, operating either the FILTER 1 CUTOFF or the FILTER 2 CUTOFF will
uniformly change both of their Cutoff frequencies. The relative offset between the Cutoff Frequency settings of
the Filters is preserved as the linked value is increased or decreased.
When this parameter is in CUTOFF + RES, operating either the FILTER 1 CUTOFF and RES or the FILTER 2
CUTOFF and RES will uniformly change both of their Cutoff frequencies. The relative offset between the Cutoff
Frequency settings of the Filters is preserved as the linked value is increased or decreased.