User's Manual
Table Of Contents
- Contents
- Introduction
- 1 – Installation and Setup
- 2 – Turning The Unit On/Off - Calibration Process
- 3 – Overview
- 4 – Front Panel Interface
- 4.1 – Home Display
- 4.2 – Sound Editing Matrix
- 4.2.1 – Oscillators (OSC)
- 4.2.2 - Mixer (MIX)
- 4.2.3 – Filters (FILTER)
- 4.1.4 – LFOs (LFO)
- 4.2.5 – Envelopes (FILTER ENV - AMP ENV)
- 4.2.6 – Modulation Matrix (MATRIX)
- 4.2.6 – Effects (FX)
- 4.2.7 – Effects Type List And Parameters
- 4.2.8 – Other Sound Editing Shortcuts
- 5 – Global Controls
- 5.1 – Presets
- 5.1.1 – The Edit Preset Menu
- 5.1.2 - Store a Preset
- 5.1.3 – Recall Preset
- 5.1.4 – Rename Preset
- 5.1.5 – Initialize A Preset
- 5.1.6 – Compare Preset
- 5.1.7 – Demo
- 5.2 – Setup
- 5.2.1 – Master Tuning
- 5.2.2 – MIDI
- 5.2.3 – Sync
- 5.2.4 – Keyboard
- 5.3 – Song
- 5.4 – Arpeggiator
- 5.5 – Sequencer
- 5.5.1 – ALT(ernative) Editing button
- 5.6 – Voice Mode: Assign System
- 6 – FAQ and Troubleshooting
- 7 – Support
UNO Synth Pro
4 – Front Panel Interface
13
4.2.2 - Mixer (MIX)
Pressing the MIXER button lights the 3rd row of text indicators.
LEVEL 1: adjusts the pre-filter volume of Oscillator 1 from 0 to 127.
LEVEL 2: adjusts the pre-filter volume of Oscillator 2 from 0 to 127.
LEVEL 3: adjusts the pre-filter volume of Oscillator 3 from 0 to 127.
NOISE: adjusts the pre-filter volume of the Noise Generator from 0 to 127.
The External audio in routing is selectable in the MIXER section inside the EDIT PRESET menu,
between PRE (so the audio enters pre-filters and became part of the audio sources) and POST (which acts as
an audio daisy chain).