User Manual
Table Of Contents
- English
- Table of Contents
- Introduction
- 1 – Installation and setup
- 2 – Turning the unit ON/OFF - Calibration process
- 3 – Overview
- 4 – Front panel interface
- 5 – Programming a Sequence
- 6 – Presets
- 7 – MIDI Implementation
- 7.1 – General
- 7.2 – Control External Devices with UNO Drum
- 7.3 – Control UNO Drum from External Devices
- 7.4 – Connecting UNO Drum to a computer via MIDI
- 7.5 – Connecting UNO Drum to a computer via USB
- 7.6 – Setting the MIDI Channel
- 7.7 – Setting the Sync Mode
- 7.8 – MIDI Soft Thru
- 7.9 – MIDI Interface Mode
- 7.10 – Element Mapping
- 7.11 – Pad note out
- 7.12 – Program Change
- 7.13 – MIDI Implementation Chart
- 8 – Specifications
- 9 – Troubleshooting
- 10 – Support
UNO Drum
7 – The Sequencer
38
CLOSED HAT: note F#2 (42)
OPEN HAT: note A#2 (46)
TOM1: note F2 (41)
TOM2: note G2 (43)
CYMBAL: note C#3 (49)
RIDE: note D#3 (51)
COWBELL: note G#3 (56)
7.11 – Pad note out
The PADs send out MIDI notes with a fixed gate (meaning a fixed time between a note ON and note OFF
message).
7.12 – Program Change
On the drum machine, KITs are recalled by MIDI Program Change. Program Change 0 will recall KIT 1 (for
consistency with UNO Synth).