User Manual
Table Of Contents
- English
- Table of Contents
- Introduction
- 1 – Installation and setup
- 2 – Turning the unit ON/OFF - Calibration process
- 3 – Overview
- 4 – Front panel interface
- 5 – Programming a Sequence
- 6 – Presets
- 7 – MIDI Implementation
- 7.1 – General
- 7.2 – Control External Devices with UNO Drum
- 7.3 – Control UNO Drum from External Devices
- 7.4 – Connecting UNO Drum to a computer via MIDI
- 7.5 – Connecting UNO Drum to a computer via USB
- 7.6 – Setting the MIDI Channel
- 7.7 – Setting the Sync Mode
- 7.8 – MIDI Soft Thru
- 7.9 – MIDI Interface Mode
- 7.10 – Element Mapping
- 7.11 – Pad note out
- 7.12 – Program Change
- 7.13 – MIDI Implementation Chart
- 8 – Specifications
- 9 – Troubleshooting
- 10 – Support
UNO Drum
4 – Front panel interface
25
TYPE 9 (Madness 1): the selection on the display shows “9”. This type repeats 4 steps in a loop from the
first available after the press of the stutter button at the double of the speed of the sequence. In this case the
AMOUNT controls the amount of steps from 50% to 100% of the steps independently from the loop that will
have a random Velocity, Decay, and Tune.
TYPE 10 (Madness 2): the selection on the display shows “10”. This type repeats 3 steps in a loop from the
first available after the press of the stutter button at the double of the speed of the sequence. In this case the
AMOUNT controls the amount of steps from 50% to 100% of the steps independently from the loop that will
have a random Velocity, Decay, and Tune plus adding a roll of 4 steps at the end of the 16 step pattern.