User Manual
Table Of Contents
- English
- Table of Contents
- Introduction
- 1 – Installation and setup
- 2 – Turning the unit ON/OFF - Calibration process
- 3 – Overview
- 4 – Front panel interface
- 5 – Programming a Sequence
- 6 – Presets
- 7 – MIDI Implementation
- 7.1 – General
- 7.2 – Control External Devices with UNO Drum
- 7.3 – Control UNO Drum from External Devices
- 7.4 – Connecting UNO Drum to a computer via MIDI
- 7.5 – Connecting UNO Drum to a computer via USB
- 7.6 – Setting the MIDI Channel
- 7.7 – Setting the Sync Mode
- 7.8 – MIDI Soft Thru
- 7.9 – MIDI Interface Mode
- 7.10 – Element Mapping
- 7.11 – Pad note out
- 7.12 – Program Change
- 7.13 – MIDI Implementation Chart
- 8 – Specifications
- 9 – Troubleshooting
- 10 – Support
UNO Drum
4 – Front panel interface
23
TYPE 7 (Tune UP): the selection on the display shows “7”. This type overlaps the Tune parameters of the
effected element going from value 0 to 127 in 8 steps (at the double of the speed of the sequence).
In this case the AMOUNT controls the number of element affected by the stutter from the Closed and Open
HiHats to all the 12 elements as shown in the picture. Amount range is 0-12.
The type is effected by the swing, division, the velocity, and the pattern length.