User Manual
Table Of Contents
- English
- Table of Contents
- Introduction
- 1 – Installation and setup
- 2 – Turning the unit ON/OFF - Calibration process
- 3 – Overview
- 4 – Front panel interface
- 5 – Programming a Sequence
- 6 – Presets
- 7 – MIDI Implementation
- 7.1 – General
- 7.2 – Control External Devices with UNO Drum
- 7.3 – Control UNO Drum from External Devices
- 7.4 – Connecting UNO Drum to a computer via MIDI
- 7.5 – Connecting UNO Drum to a computer via USB
- 7.6 – Setting the MIDI Channel
- 7.7 – Setting the Sync Mode
- 7.8 – MIDI Soft Thru
- 7.9 – MIDI Interface Mode
- 7.10 – Element Mapping
- 7.11 – Pad note out
- 7.12 – Program Change
- 7.13 – MIDI Implementation Chart
- 8 – Specifications
- 9 – Troubleshooting
- 10 – Support
UNO Drum
4 – Front panel interface
21
TYPE 5 (Fill style 1): the selection on the display shows “5”. This type adds a pre-programmed pattern of 16
steps to the current pattern of elements, starting from the first step available, as showed in the picture.
In this case, the AMOUNT controls the number of elements affected by the stutter from Kick1 to all of the 12
elements as shown in the picture. Amount range is 0-12.
The type is effected by the swing and the division, but not the pattern length and velocity which is fixed at 127.