User Manual
Table Of Contents
- English
- Table of Contents
- Introduction
- 1 – Installation and setup
- 2 – Turning the unit ON/OFF - Calibration process
- 3 – Overview
- 4 – Front panel interface
- 5 – Programming a Sequence
- 6 – Presets
- 7 – MIDI Implementation
- 7.1 – General
- 7.2 – Control External Devices with UNO Drum
- 7.3 – Control UNO Drum from External Devices
- 7.4 – Connecting UNO Drum to a computer via MIDI
- 7.5 – Connecting UNO Drum to a computer via USB
- 7.6 – Setting the MIDI Channel
- 7.7 – Setting the Sync Mode
- 7.8 – MIDI Soft Thru
- 7.9 – MIDI Interface Mode
- 7.10 – Element Mapping
- 7.11 – Pad note out
- 7.12 – Program Change
- 7.13 – MIDI Implementation Chart
- 8 – Specifications
- 9 – Troubleshooting
- 10 – Support
UNO Drum
4 – Front panel interface
20
TYPE 4 (Loop triplets 2): the selection on the display shows “4”. This type repeats 6 steps in a loop from the
first available after the press of the stutter button. In this case the AMOUNT controls the number of elements
affected by the stutter from the Kick1 to all of the 12 elements, as shown in the example when starting from step
1. Amount range is 0-12.