User Manual
Table Of Contents
- English
- Table of Contents
- Introduction
- 1 – Installation and setup
- 2 – Turning the unit ON/OFF - Calibration process
- 3 – Overview
- 4 – Front panel interface
- 5 – Programming a Sequence
- 6 – Presets
- 7 – MIDI Implementation
- 7.1 – General
- 7.2 – Control External Devices with UNO Drum
- 7.3 – Control UNO Drum from External Devices
- 7.4 – Connecting UNO Drum to a computer via MIDI
- 7.5 – Connecting UNO Drum to a computer via USB
- 7.6 – Setting the MIDI Channel
- 7.7 – Setting the Sync Mode
- 7.8 – MIDI Soft Thru
- 7.9 – MIDI Interface Mode
- 7.10 – Element Mapping
- 7.11 – Pad note out
- 7.12 – Program Change
- 7.13 – MIDI Implementation Chart
- 8 – Specifications
- 9 – Troubleshooting
- 10 – Support
UNO Drum
4 – Front panel interface
18
TYPE 2 (Loop 4): the selection on the display shows “2”. This type repeats 4 steps in a loop from the first
available after the press of the stutter button. In this case the AMOUNT controls the number of element affected
by the stutter from the Kick1 to all the 12 elements as showed in the picture showing the example when starting
from step 1.Amount range is 0-12.