User's Manual
Table Of Contents
- English
- Contents
- Safety information
- iRig Pro Duo I/O
- Register your iRig Pro Duo I/O
- iRig Pro Duo I/O overview
- Installation and setup
- Connecting an external power supply
- iRig Pro Duo I/O LEDs
- Direct monitoring
- Connecting microphones
- Connecting instruments
- Connecting monitors and headphones
- MIDI IN/OUT
- Setting input gain on iRig Pro Duo I/O
- Troubleshooting
- Specifications
- Warranty
- Support and more info
- Japanese 日本語
English
13
Dynamic microphones
Before connecting dynamic microphones make sure phantom power is turned OFF. Check that the Phantom
Power switch is in the OFF position and that the Phantom LED is turned off.
Condenser microphones
Most condenser microphones require external phantom power. If phantom power is ON, switch it OFF, and
then connect your microphone. Turn phantom power ON only after the microphone is connected. Once it’s
turned ON, check that the phantom power LED has become blue (it will flash for a few seconds before staying
on). If the LED doesn’t turn blue, check that working batteries are inserted in the iRig Pro Duo I/O’s battery
compartment on the bottom side, and that an application that is using iRig Pro Duo I/O is open. Phantom power
will NOT turn ON if iRig Pro Duo I/O is in standby (status LED lit up dark blue).