Installation Manual

English
32
• Reached the TCH position pess the DATA push-knob to confirm you want to enable/disable the touch
feature;
• The display will show CC and will cycle between CC and SNS. The CC (control change) allows you to
enable or disable the sending of the CC message associated to the touch of each knob; the SNS (sensing)
allows you to enable or disable the capacite sensitive feature of the knobs. These are the possible
combinations: CC (OFF) and SNS (ON), default -> the CC assigned to the touch of the knob is OFF; CC
(ON) and SNS (OFF) -> the CC assigned to the touch of the knob is sent when you start rotating the knob
and not when the knob is just touched;
• If you select, for example, CC:
• By rotating the DATA knob clockwise you’ll turn ON the feature; turning counter-clockwise the DATA knob
you’ll turn it OFF. By default this feature is set to OFF;
• If you select, for example, SNS:
• By rotating the DATA knob clockwise you’ll turn ON the feature; turning counter-clockwise the DATA knob
you’ll turn it OFF.
• To confirm your input press the DATA push-knob;
• The keyboard will exit automatically the Edit Mode;
• You can exit the Edit mode any time by pressing the CANCEL/NO key.
5.2.4 Send “All Notes Off” MIDI message
Sometimes it may be necessary to stop all notes playing on the current MIDI channel when they are stuck or
when controllers are not resetting properly.
iRig Keys I/O can send MIDI CC# 121 + 123 to reset all controllers and stop all notes. To reset all controllers and
set all notes off:
• Enter Edit Mode by pressing the ALT and EDIT buttons;
• The display will show GLO. Press the DATA push-knob to confirm you want to edit a parameter in the global
menu;
• By rotating the DATA knob you will cycle between the parameters of the Global menu;
• Reached the OFF position pess the DATA push-knob to confirm you want to send a note off message;
• The keyboard will exit automatically the Edit Mode;
• You can exit the Edit mode any time by pressing the CANCEL/NO key.