Installation Manual

English

1. Program Changes are sent sequentially by using the PROG up and PROG down buttons.

2. Program Changes are sent directly by sending a specific Program Change number from within EDIT mode.

After sending a specific Program Change number, the PROG up and down buttons will work sequentially

from that point.

To send a specific Program Change number:

• Enter Edit Mode by pressing the ALT and EDIT buttons;

• The display will show GLO. Press the DATA push-knob to confirm you want to edit a parameter in the global

menu;

• By rotating the DATA knob it will cycle between the parameters of the Global menu;

• Reached the PC (programm change) position pess the DATA push-knob to confirm you want to set a

Programm change;

• The display will show NBR (number) to let you insert the PC number. Insert the PC number (from 0 to 127)

with the keys marked from 0 to 9. You can cancel your input with the CANCEL/NO key;

• To confirm your input press the DATA push-knob;

• The keyboard will exit automatically the Edit Mode;

• You can exit the Edit mode any time by pressing the CANCEL/NO key.

5.2.2 Keyboard edit

• Enter Edit Mode by pressing the ALT and EDIT buttons;

• The display will show GLO. Press the DATA push-knob to confirm you want to edit a parameter in the global menu;

• By rotating the DATA knob you will cycle between the parameters of the Global menu;

• Reached the KEY position pess the DATA push-knob to confirm you want to edit the keyaboard parameters;

• The display will shows CH (MIDI channel) and by rotating the DATA knob it will cycle between VEL (velocity)

-> TRS (transpose).

5.2.2.1 Set the MIDI Transmit Channel of the keyboard

MIDI instruments can respond to 16 different MIDI channels. For iRig Keys I/O to play an instrument, you need

the iRig Keys I/O MIDI Transmit Channel to match the receiving channel of your instrument.

To set the MIDI Transmit Channel: