User Manual

English
17
Example
If you need to play a song that has been recorded in key of D#, but you would like to play it on the keyboard as
if it was in C, do the following:
• Enter in EDIT mode.
• Press the key (TRANSP).
• Press any D# key on the keyboard.
From this moment on when you press a C key on the keyboard, iRig Keys 2 will actually send a D# MIDI note.
All other notes are transposed by the same amount.
4.9 Reset iRig Keys 2
iRig Keys 2 can be reset to its original factory state. This can be done independently for each one of the SETs.
To reset iRig Keys 2’s SET:
• Load the SET you would like to reset.
• Enter EDIT mode (see beginning of Chapter 4).
• Press the key (RESET).
• Both PROG buttons will flash to show the SET has been reset, and iRig Keys 2 will automatically exit EDIT
mode.
5 SETs
iRig Keys 2 offers many options to satisfy the most demanding user. However, when the keyboard is used live or
to control many different instruments, it could be time consuming and tricky to manually set all the parameters
you need each time.
For this reason, iRig Keys 2 has 4 user configurable presets that can be recalled on the fly by pressing just one
button, these are called SETs.
5.1 How to load a SET
To load any of the four SETs just press the SET button. Each time the SET button is pressed, iRig Keys 2 loads
the NEXT SET, cycling this way:
-> SET 1 -> SET 2 -> SET 3 -> SET 4 -> SET 1 …