User Manual

English
16
To send a specific Program Change number:
• Enter EDIT mode (see beginning of Chapter 4).
• Press the key (PROG), both OCT buttons will start flashing.
• Enter the Program Change number using the keys marked from 0 to 9. Valid numbers are from 1 to 128, so
you can enter up to three digits consecutively when needed.
• Press the key (ENTER/YES) to confirm your input. Both PROG buttons will flash to show the setting has
been accepted, and iRig Keys 2 will automatically exit EDIT mode.
4.7 Send “All Notes Off” MIDI message - iRig Keys 2 and iRig Keys 2 Pro
Sometimes it may be necessary to stop all notes playing on the current MIDI channel when they are stuck or
when controllers are not resetting properly.
iRig Keys 2 can send MIDI CC# 121 + 123 to reset all controllers and stop all notes.
To reset all controllers and set all notes off:
• Enter EDIT mode (see beginning of Chapter 4).
• Press the key (ALL NOTES OFF).
Both PROG buttons will flash to show the reset has been sent, and iRig Keys 2 will automatically exit EDIT
mode.
4.8 Transpose the keyboard in semitones - iRig Keys 2 and iRig Keys 2 Pro
The iRig Keys 2 keyboard can be transposed in semitones. This can be useful when, for example, you need to
play a song that is in a difficult key, but you still want to physically play it in an easier or more familiar key.
To transpose iRig Keys 2:
• Enter EDIT mode (see beginning of Chapter 4).
• Press the key (TRANSP), both OCT buttons will start flashing.
• Press any note on the keyboard: from this moment on, when you press a C key, iRig Keys 2 will actually
send the MIDI note you pressed at this step.
• Both PROG buttons will flash to show the semitone transpose has been set, and iRig Keys 2 will
automatically exit EDIT mode.