User Manual
Table Of Contents
- English
- Contents
- AXE I/O SOLO
- Register your AXE I/O SOLO
- Front panel
- Rear panel
- 1 Installation and setup
- 2 Dedicated guitar features
- 3 Setup your DAW
- 4 Connecting microphones
- 5 Connecting instrument
- 6 Connecting loudspeakers and headphones
- 7 Direct monitoring
- 8 Control software
- 9 Specifications
- Warranty
- Support and more info
- Regulatory
- Japanese (日本語)
English
20
THD, PURE mode: 0.002 % (-1dBFS input)
THD, JFET mode: 0.5 %
Mic Input
Configuration: Class-A discrete differential microphone preamp, pin 2 hot
Input impedance: 4 kOhms differential
Input level, min gain: 0 dBFS is obtained with a +9 dBu signal at the XLR input
Input level, max gain: 0 dBFS is obtained with a -44 dBu signal at the XLR input
Frequency response: From 7 Hz to 32 kHz within 0.5 dB (96 kHz sample rate)
Dynamic Range: 116 dB(A)
THD+N: -104 dB(A) at -10 dBFS
Line Input
Configuration: Class-A discrete differential line receiver, tip hot
Input impedance: 20 kOhms differential
Input level, min gain: 0 dBFS is obtained with a +26 dBu signal at the TRS input
Input level, max gain: 0 dBFS is obtained with a -27 dBu signal at the TRS input
Frequency response: From 7 Hz to 32 kHz within 0.5 dB (96 kHz sample rate)
Dynamic Range: 117 dB(A)
THD+N: -104 dB(A) at -10 dBFS
Warranty
For detail on your product’s warranty, please visit:
www.ikmultimedia.com/warranty
for the complete warranty policy.
Support and more info
www.ikmultimedia.com/support
www.ikmultimedia.com/products/axeiosolo