User Manual
Table Of Contents
- English
- Contents
- AXE I/O SOLO
- Register your AXE I/O SOLO
- Front panel
- Rear panel
- 1 Installation and setup
- 2 Dedicated guitar features
- 3 Setup your DAW
- 4 Connecting microphones
- 5 Connecting instrument
- 6 Connecting loudspeakers and headphones
- 7 Direct monitoring
- 8 Control software
- 9 Specifications
- Warranty
- Support and more info
- Regulatory
- Japanese (日本語)
English
11
Note: AXE I/O SOLO is very useful for feeding analogue stomp boxes from DAW tracks using the AMP output.
The best way to get the Stomp signal back into the DAW is by using Instrument input 1. This way the Z-TONE
circuit will also be very useful because most vintage stomps can actually change the way they sound depending
on the load impedance, so experimentation in this usage is very welcome as well.
2.6 External control
Connect up to two external controller here to send MIDI control messages. You can use any available
“momentary” or “sustain pedal” type foot switch that includes a 1/4 inch connector. Both normally open
and normally closed switches are supported. AXE I/O SOLO also support continuous expression pedals for
controlling realtime parameters like Wah, Volume, FX depth etc. Any 1/4” TRS connector expression pedal
will work with AXE I/O SOLO. MIDI messages associated with these controllers are freely assignable from the
“Control app”.