Installation Guide

Installation Guide
K0J00025-EN-A03
IJINUS – 25 ZA de Kervidanou 3 – 29300 MELLAC – FRANCE - www.ijinus.com - sales@ijinus.com
7
b. First step : Run Avelour and connect to the sensor to configure
After connection of the Wiji kit (or the Wiji key) on your computer USB port, run the Avelour software. Click on
the button “Connect to a wireless device” then the logger will be directly visible by its part number (SN) without
the need to activate anything else (ex: IJA0101-0000 3559). Locate the sensor's serial number (SN) on the sensor
label and click "OK".
On the first connection with the sensor only the serial number will appear. The following connections you will
see also the name of the installation site or another name that you define.
c. Second step : Selection of the sensor to configure, eventually a firmware update would
be suggested
During its connection with the sensor, the following pop up appears:
When connected, and only if the sensor already has measurements in memory, the following options will
suggest you to retrieve the measures:
After your choice of these options, if the sensor is not up to date (case of new firmware developed since your
last connection or you are now connected with a new version of the software Avelour). It is strongly
recommended to read carefully the different messages in the options windows.
The firmware update can last a moment, so it is advised to do it while in your office. On-site prefer the best
radio connection (so not if the metal cover of a manhole is closed).