User Manual

ENGLISH
BEFORE YOU OPERATE THE MONITOR 7
CONNECTING YOUR MONITOR
Ensurethatboththecomputerandthemonitorareswitchedo󰀨.
Connect the computer to the monitor with the signal cable.
Connect the computer to the monitor with the USB Cable.
ConnectthePowerCabletothemonitorrstandthentothepowersource.
Turn on your monitor and computer.

Makesurethatthebuildinginstallationhasacircuitbreakerof120/240V,20A(maximum).

The signal cables used for connecting the computer and monitor may vary with the
type of computer used. An incorrect connection may cause serious damage to both
the monitor and the computer. The cable supplied with the monitor is for a standard
connector. If a special cable is required please contact your local iiyama dealer or
regionaliiyamao󰀩ce.

MakesureyoutightenthengerscrewsateachendoftheSignalCable.

The Class I pluggable equipment Type A must be connected to protective earth.

The socket-outlet shall be installed near the equipment and shall be easily accessible.
[Example of Connection]
<Back>
NOTE
* DVI-D cable is not supplied with the monitor. If you use low quality DVI-D cable, it may cause a
result of electro-magnetic interference. Please contact the iiyama Support Centre in your country
if you wish to connect the monitor via the DVI input.
F
or
Power Cable (Accessory)
Computer
DVI-D Cable (Not included)*
USB Cable (Accessory)
Audio Cable (Not included)
DisplayPort Cable
(Accessory)
AV Equipment etc.
mDP-DP Cable (Accessory)
Notebook
HDMI Cable (Accessory)